Induction Heat Assisted End Milling of Inconel 718 and Ti6Al4V Alloys
A comparative Assessment of Machinability in terms of Chatter, Surface Roughness and Tool Performance
(Sprache: Englisch)
Inconel 718 is the most widely used in the aerospace industries, especially for gas turbine hot section components. Titanium alloys, on the other hand, have very high strength-to-weight ratio making them very suitable for aircraft engines and airframe...
Leider schon ausverkauft
versandkostenfrei
Buch
71.90 €
Produktdetails
Produktinformationen zu „Induction Heat Assisted End Milling of Inconel 718 and Ti6Al4V Alloys “
Klappentext zu „Induction Heat Assisted End Milling of Inconel 718 and Ti6Al4V Alloys “
Inconel 718 is the most widely used in the aerospace industries, especially for gas turbine hot section components. Titanium alloys, on the other hand, have very high strength-to-weight ratio making them very suitable for aircraft engines and airframe manufacture. They account for 30% of the total engine mass in commercial and 40% in military projects. However, both these strategic materials have poor machinability, as a result of which they have dominated the major research interests in metal cutting industries in the past decades. One of the techniques to improve machinability is the use an external heat source during machining. LAM applications offered significantly lower cutting force, higher metal removal rate and smoother surface finish, however, high costs of lasers slowed down its implementation. A new approach is heat assisted machining using inducting heating suitable for end milling operation. This book reports a comparative analysis of machinability of these two very strategic materials and their behavior to induction heat assisted machining in terms of tool wear, cutting forces, surface roughness and vibration/chatter.
Autoren-Porträt von A.K.M. Nurul Amin, Mohammad Ishtiyaq Hossain
Amin, A.K.M. NurulProf. A.K.M. Nurul Amin is a Senior Professor at International Islamic University Malaysia. He has completed a large number research projects and supervised several PhD and a large number of Master students. He has authored of 9 books, edited another 5 books and published over 300 technical articles. He has 1 patent granted and 7 others applied.
Bibliographische Angaben
- Autoren: A.K.M. Nurul Amin , Mohammad Ishtiyaq Hossain
- 2013, 196 Seiten, Maße: 22 cm, Kartoniert (TB), Englisch
- Verlag: LAP Lambert Academic Publishing
- ISBN-10: 3659439932
- ISBN-13: 9783659439933
Sprache:
Englisch
Kommentar zu "Induction Heat Assisted End Milling of Inconel 718 and Ti6Al4V Alloys"
0 Gebrauchte Artikel zu „Induction Heat Assisted End Milling of Inconel 718 and Ti6Al4V Alloys“
Zustand | Preis | Porto | Zahlung | Verkäufer | Rating |
---|
Schreiben Sie einen Kommentar zu "Induction Heat Assisted End Milling of Inconel 718 and Ti6Al4V Alloys".
Kommentar verfassen