Low Power VCO Design in CMOS
(Sprache: Englisch)
This work covers the design of CMOS fully integrated low power low phase noise voltage controlled oscillators for telecommunication or datacommuni- tion systems. The need for low power is obvious, as mobile wireless telecommunications are battery operated....
Leider schon ausverkauft
versandkostenfrei
Buch
101.60 €
50 DeutschlandCard Punkte
sammeln
- Lastschrift, Kreditkarte, Paypal, Rechnung
- Kostenlose Rücksendung
- Ratenzahlung möglich
Produktdetails
Produktinformationen zu „Low Power VCO Design in CMOS “
Klappentext zu „Low Power VCO Design in CMOS “
This work covers the design of CMOS fully integrated low power low phase noise voltage controlled oscillators for telecommunication or datacommuni- tion systems. The need for low power is obvious, as mobile wireless telecommunications are battery operated. As wireless telecommunication systems use oscillators in frequency synthesizers for frequency translation, the selectivity and signal to noise ratio of receivers and transmitters depend heavily on the low phase noise performance of the implemented oscillators. Datacommunication s- tems need low jitter, the time-domain equivalent of low phase noise, clocks for data detection and recovery. The power consumption is less critical. The need for multi-band and multi-mode systems pushes the high-integration of telecommunication systems. This is o?ered by sub-micron CMOS feat- ing digital ?exibility. The recent crisis in telecommunication clearly shows that mobile hand-sets became mass-market high-volume consumer products, where low-cost is of prime importance. This need for low-cost products - livens tremendously research towards CMOS alternatives for the bipolar or BiCMOS solutions in use today.
Inhaltsverzeichnis zu „Low Power VCO Design in CMOS “
Part I: VCO Design: VCO Introduction- Tank Properties
- VCO Design Theory
- Low Power Low Phase Noise VCO Design
Part II: CMOS Devices for VCO Design: MOS-Transistors
- Inductors
- Capacitors
Part III: Fully Integrated VCO Designs: VCO Design Guide
- 1.3 GHz Fully Integrated CMOS VCO for GSM
- 1.8 GHz Quadrature VCO Design for DCS1800 and GSM
- A Fully Integrated 51 GHz VCO in 0,13 µm CMOS
- Dual Band 1 GHz VCO Design
Part IV: General Conclusion.
Autoren-Porträt von Marc Tiebout
Marc Tiebout, born in Asse (Belgium) in 1969, received the M.S. degree in electrical and mechanical engineering in 1992 from the Katholieke Universiteit Leuven (Belgium), and his Ph.D. from the Technical University of Berlin in 2004. In 1993 he joined Siemens AG, Corporate Research and Development, Microelectronics in Munich (Germany), designing analog integrated circuits in CMOS and BiCMOS technologies. In 1997 he switched to the design of radio frequency devices and building blocks in sub-µm CMOS technologies. From summer 1999 to summer 2001, he was with Infineon Technologies AG, Wireless Products, where he worked on RFCMOS circuits and transceivers for cellular wireless communications. He was workpackage leader for the CMOS part of the EC-funded LEMON project (single chip UMTS transceiver). Currently he is with Infineon Technologies AG, Corporate Research, Munich. His main interest goes into low power highest frequency circuits and systems in standard CMOS. Marc Tiebout has authored and co-authored many publications and patents, mainly in the field of RFCMOS and has been member of IEEE since 1990.
Bibliographische Angaben
- Autor: Marc Tiebout
- 2005, 132 Seiten, Maße: 23,5 cm, Gebunden, Englisch
- Verlag: Springer
- ISBN-10: 3540243240
- ISBN-13: 9783540243243
Sprache:
Englisch
Kommentar zu "Low Power VCO Design in CMOS"
0 Gebrauchte Artikel zu „Low Power VCO Design in CMOS“
| Zustand | Preis | Porto | Zahlung | Verkäufer | Rating |
|---|
Schreiben Sie einen Kommentar zu "Low Power VCO Design in CMOS".
Kommentar verfassen